Made a base and provision to wall hang.
Found a bit of plywood the right so cleaned it up on disc & belt sander. Here I measured and marked so the frame is centered on the stand and used some scrap wood with clamps to fix the location so I can turn it over to put in the screws.
Check all around to make sure it’s centered.
Turn it upside down and drive screws in pre-drilled and countersunk holes.
Looks OK…will stain the base.
It can also be hung on a wall, after removing the stand 
I can see the finish line, time for a cuppa break.
We start the next session by heating up the hot glue gun.
