Category: DJ TV Stand
DJ 58″ TV visual display unit – part 5 video clip
DJ 58″ TV visual display unit – part 5
The front of each side will have LED strip lighting so in this session we are setting up to route those channels.
The LED strip is 8mm wide so we’ll use a 12mm router bit.
Continue reading “DJ 58″ TV visual display unit – part 5”DJ 58″ TV visual display unit – part 4
Got ready this morning to start a solo session and after a few minutes had to quit !!!
Just started to bore the next hole and had to stopÂ
Continue reading “DJ 58″ TV visual display unit – part 4”DJ 58″ TV visual display unit – part 3
Session summary – spent a few hours this morning and expended a fair bit of energy – then gave upÂ
DJ 58″ TV visual display unit – part 2
Completed the second side, that is the right side in 1/3 the time it took to do the first side – the left side.
Ready for the next stage of the build each side will have four large holes.
Continue reading “DJ 58″ TV visual display unit – part 2”DJ 58″ TV visual display unit – part 1
After a good start with Philip Tyme on Saturday I am back on this job cos for the last two days got dragged away doing other stuff.
Doing some planning before we start. This Torx wood screw is just the right length and I have a dog food tin full of them.
Continue reading “DJ 58″ TV visual display unit – part 1”DJ 58″ TV visual display unit – start
Doing a job for Philip Tyme to make a integrated display TV unit for DJ gigs.
For the Bunnings plywood we both had to ring around, see the picture further down the page.
Nothing out his way and in my side the only one was Notting Hill so off yesterday morning in the Camry to buy 3 x 1200 x 600 x 18mm @ $35 per sheet. Loaded nicely across the back seat. We are using this picture that Philip found on the net.