The stands are basically finished except for one last addition – bucket support. As mentioned, one stand will be inside the other outside and need to provide water for three greyhounds so rather than the usual drink bowls we are using 8L buckets. The bucket handle prevents the rim from sitting flush on the top so we need some extra support. Continue reading “Greyhound drink stands – Part 6”
Category: Greyhound Drink Stands
Greyhound drink stands – Part 5
Glue-up of the 2nd stand the 1st is already done. Continue reading “Greyhound drink stands – Part 5”
Greyhound drink stands – Part 4
We are going to put a decorative edge around the edges of the stand tops.
Greyhound drink stands – Part 3 Video
Using the Ryobi trim router – is good.
Greyhound drink stands – part 3
In this session we are routing the bucket holes.
At this point we have two stands dowelled up and ready for glue-up but before that we need to cut out the bucket holes.
Greyhound drink stands – part 2
After cutting the panels had a think about how to assemble the stands as I don’t want any screw fixings to show. Pondered about pocket screws the decided to hold them together with wood dowels.
New unopened ALDI WorkZone wood dowel kit.
Greyhound drink stands – part 1
Family request to make two elevated water dog bowl stands for three greyhounds, one for inside the other outside.
This one pops up when searching the web for ideas so I’ll base my design on that and make it higher – grey height.