In the first session for this project we made the motor disc, with that done next job is to make the sander disc.
Cutting the sander disc on my homemade 14″ bandsaw.
Day: September 11, 2018
12" Disc sander – 1
Collecting and preparing the parts to make a disc sander.
From stock I need to cut the end off this 2400 x 300 Melamine board.
Moving the 12″ mitre saw so the long board can stick out the door.
Measure and mark 300mm off the end.
Now over to the mitre saw.
The Ozito 12″ sliding mitre saw has the capacity to cut across 12″ or 300mm 
With that done we can return the Melamine to stock.
Boards stored behind the ‘entertainment unit’ that I picked up off someone’s hard rubbish 
This disc will bolt onto the grinder motor shaft.
The sander disc will be screwed to the motor disc. Back soon…