Finished off the lower blade guide assembly.
Put the table back on to do some test cutting.
Month: August 2017
8” Bandsaw – Lower blade guides continued
With bearing guides above and now below the table the blade should hold it’s course even better on the cut line.
Continue reading “8” Bandsaw – Lower blade guides continued”
8” Bandsaw–Lower blade guide assembly
Back to the bandsaw, we still need to do the lower bearing guides. With the table removed sit and think for a while…thinking.
8” Bandsaw – Revised the tension bridge support.
This one is from pine and fills the whole centre section, not only across but front to back as well – it’s like a cross.
Continue reading “8” Bandsaw – Revised the tension bridge support.”
Table saw – Mini crosscut sled
During construction of the bandsaw (and other stuff around the workshop) I had need to cut small parts, to small and to dangerous for the big 12″ sliding mitre saw, so I just made a small crosscut sled for the table saw.
The base and tracks are laminate flooring with front & back from pine.