This is another interesting stage where we can start planning to setup a temporary table and begin construction of the upper blade guides.
Even with a temporary table I still need to know where the blade position will be so I can make the blade access cut on the table saw. So the first thing is to mount the blade, and make sure tension and alignment are correctly set.
With the basic blade guide arm setup and before we start making the actual blade guides we need to make ready a temporary table and put that aside for now.
Running out of off cuts so got down a 2400mm length from my stock of MG10 pine. No problem cutting this stuff on the big Ozito 12” sliding mitre saw. The stand arms will extend out to 2 metres. Here only the right is extended.
