Category Archives: Al’s Workshop

Finished cutting the doggie yesterday so now remove the pattern.

Made the frame that sits inside the back of the picture frame and cut out the doggie pattern on the scroll saw. Prepared a 3mm MDF blank from scrap for for the pattern.

Cutting the base board for the new project.

As mentioned in a previous post rather the building the frame for this Goldie night light I’m going to use a regular picture frame. I was after a A4 wood box frame but had to settle for this, pretty close … Continue reading →

The Samoyed night is completed. This morning screwed the stand onto the frame.

Hot glued the LED’s and stained the stand. A dab of glue on the four standoff’s will fix the doggie to the base board.

Made a base and provision to wall hang. Found a bit of plywood the right so cleaned it up on disc & belt sander. Here I measured and marked so the frame is centered on the stand and used some … Continue reading →

The controller is set to Dusk mode, only works at night (semi-dark to dark) and turns ON when the front mounted PIR (sensor) is triggered by movement. There is also a Day mode where you manually turn ON/OFF – anytime.