Continued on adding the four ‘legs’ that are not really legs but rather corner supports.
That C clamp locking pliers with extended reach was purchased from the market last Sunday – very handy.

Worked around to finish the bottom and turned it upside down to do the top.

Finished the top and while it’s upside down put on a set of castors.
Hmm…got a feeling it’s going to end up to high.

Cut a board for the top of the base and using brackets to secure.

Took the base off the bench onto the floor and yep, with the castors plus the top it’s to high. I need to reduce the height by 100 – 150mm, down to the same height as the low table the saw is sitting on now – a bit of re-work.