Rough Collie on stand – part 5

Posted on 12/01/2020 by AlanM52

Just finished hot gluing the Fairy LED’s onto the back of the doggie so turned it over to check the lighting effect. Also did some more planning about installing the LED controller.

Allowing for sunlight streaming in through the four skylights and two back windows of the workshop and with cardboard propped up at the back the lighting looks OK.
Allowing for sunlight streaming in through the four skylights and two back windows of the workshop and with cardboard propped up at the back the lighting looks OK.
Rather than the back of a napkin I’m recycling a used sheet of A4 paper. The middle bit of the ticked sketch is a slide switch to change between Normal and Remote operation.
Bought for stock a few different slide switches in packets pf 10. I am using this DPST slide switch (double pole single through) to switch between Normal and Remote operation.
Unknown's avatar

About AlanM52

Retired
This entry was posted in Al's Workshop, Night Lights. Bookmark the permalink.

Leave a comment