Al’s Workshop – Batman light part 13

Posted on 05/01/2020 by AlanM52

From the lighting tests last night two of the LEDS are showing up and need to be moved further inwards.

The LEDS here above the letter A need to be in or up but the RGB plug is in the way.
I was going to cut the plug off and solder directly onto the controller pins but…let’s cut the boot off the plug and see how we go.
Yep…that’s good and push the strip a bit further
Hot glue the RGB cable back onto it’s plug and bow the LED’s to the left of that up a bit.
The other spot is here so trim a bit off the block.
That should do it and now dab wood glue on all the staple strip retainers.
While that’s drying spray the back panel and off for a cuppa break,
Unknown's avatar

About AlanM52

Retired
This entry was posted in Al's Workshop, Night Lights. Bookmark the permalink.

Leave a comment